Matthew
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Out of Filament Mid Print
#1
One of the most irritating aspects of running a print especially those longer prints.  This frustration can be worse if you don't have a particular filament to replace it with to keep the print moving.  

What is your response?  Do you run a spool of filament dry before changing it out?  Do you keep more than one of each type?  How do you address this when you are printing?
Reply



Forum Jump:


Users browsing this thread:
1 Guest(s)

Powered By MyBB, © 2002-2025 Melroy van den Berg.